Ductwork, Ventilation & Sheet Metal in Hammonds Plains / Fall River
Hammonds Plains and Fall River see larger custom homes, detached garages and workshops, and bigger ducted systems that need properly-sized, fabricated ductwork and long runs.
The homes we work on in Hammonds Plains & Fall River
These are larger custom homes on bigger lots and acreage — higher ceilings, bonus rooms over garages, detached garages and workshops, and often no natural gas (electric, propane or oil). Longer runs and bigger volumes make duct sizing and fabrication matter more than anywhere else in HRM.
- Large custom homes on acreage with long duct runs
- Bonus rooms over garages that run cold and need dedicated airflow
- Detached garages and workshops to heat and ventilate
- Homes off natural gas, on electric, propane or oil
What a retrofit usually involves out here
Bigger homes need bigger, fabricated ductwork — not stock parts stretched to fit. We build trunk lines for long runs, fix the airflow in hard-to-heat bonus rooms, and ventilate shops and garages properly.
- Fabricated trunk lines sized for large homes and long runs
- Solving airflow in bonus-room-over-garage spaces
- Workshop and detached-garage heating and ventilation
- HRV/ERV for large, tightly built homes
New custom builds in Hammonds Plains & Fall River
Custom builds here are where fabrication pays off: trunk-and-branch built to the plan, multi-zone ducted heat pumps, and ventilation sized for the whole house and the shop.
- Custom-fabricated trunk-and-branch built to the floor plan
- Multi-zone ducted heat-pump distribution
- ERV/HRV and shop ventilation sized for the build
Most-requested work in Hammonds Plains / Fall River
- Custom Sheet Metal Fabrication — Elbows, transitions, plenums, fittings, flashing and custom pieces — fabricated to fit.
- Ductwork Installation & Replacement — New duct runs, replacements, trunk and branch lines, transitions and clean sheet metal installation.
- Heat Pump Ductwork & Retrofit Prep — Switching from oil or going ducted? We assess and modify the ductwork before the equipment goes in.
- HRV / ERV Installation — Fresh-air ventilation and ducting for tight new builds and older moisture-prone Halifax homes.
From Hammonds Plains to Fall River and Wellington, the bigger and more custom the home, the more it pays to have the ductwork fabricated to fit rather than forced. TrueFlow is owned and operated by Caleb Pardy, Sheet Metal Worker, serving Hammonds Plains / Fall River and the rest of Halifax Regional Municipality (HRM), Nova Scotia.
Need ductwork or ventilation work in Hammonds Plains / Fall River?
Send the details and a few photos — we'll get you a practical quote.
Request a Quote